Send Message
Home News

Metallographical Cold Mounting

Certification
China Dongguan Quality Control Technology Co., Ltd. certification
China Dongguan Quality Control Technology Co., Ltd. certification
Customer Reviews
The touch screen micro vickers hardness tester has been installed a few weeks ago, everything is OK. Thanks for your advice and excellent service.

—— Mr. David Chambers

Thanks for the fast delivery and our customer is very satisfied for the rockwell hardness tester, and hope more orders soon.

—— Neil Renato

After we visited the customer, they finally decided to purchase Brinell hardness tester iBrin-413Z, now we have installed the unit at customer’s site,

—— Fermin Lee

Thank you for the indenters (diamond  cone 120 degrees). We recently got it and already tested it. Indenters  are good as we expected. 

—— Dalius Skinulis

The Measurements are good for Brinell Tester HBST-3000.

—— Sun Chull Kim

Hey, the hardness tester iVick-484ST was installed last week and works well, thanks for the professional support.

—— Sabinian Smith

I am glad to inform you that the installation of the SHB-3000C Brinell hardness tester has been finished successfully. I would like to thank you!

—— Robbin

I'm Online Chat Now
Company News
Metallographical Cold Mounting
Latest company news about Metallographical Cold Mounting

Cold mounting requires no pressure and little heat, and is a means of mounting large numbers of specimens more rapidly than by compression mounting.

 

Materials for cold mounting are classified as polyesters, epoxides and acrylics.
Polyesters are transparent and usually water clear;
Epoxides are almost transparent and straw color;
Acrylics are opaque.

 

Cold mounting materials of all three classifications are two component systems that consist of resin and a hardener; both the resin and the hardener can be liquid, both can be solids, or one can be liquid and the other a solid.

 

Mixing of the resin and the hardener produces exothermic polymerization, and therefore this operation is crytical in producing a satisfactory cure and limiting the temperature to a permissible level. The temperature rise may reduced at the expense of longer curing time.

 

Castable Mounting Resin Properties:

Note EPOXY ACRYLIC POLYCAST Resin
Type Epoxy resin and hardener Acrylic resin and powder Polyester resin and hardener
Peak Temperature 82℉ 80℉ 100℉
Shore D Hardness 82 80 76
Cure Time 6-8 hours 5-8 minutes 6-8 hours
Comments Moderate hardness, low shrinkage, transparent Very fast curt, translucent, some shrinkage Transparent, clear

 

Pub Time : 2017-02-28 10:56:17 >> News list
Contact Details
Dongguan Quality Control Technology Co., Ltd.

Contact Person: Mr. Raymond Chung

Tel: 86-13711988687

Fax: 86-769-22784276

Send your inquiry directly to us (0 / 3000)